Other Products
Sakrete Concrete Expansion Joint is a flexible, easy-to-install material for concrete expansion and isolation joints. Available in 3/8″ thick X 5-1/2″ wide X 10′ long for 6″ slabs and 3/8″ thick X 3-1/2″ wide X 10′ long for 4″ slabs.
This product is a fine, white, high purity product which has been specially hydrated for convenient trouble free use. When properly combined with cement and sand it will provide a superior quality mortar. This product is defined by ASTM C 207. Improves mortar bond to masonry units such as brick, concrete block and stone. Increased bond strength aids in the prevention of cracking water leakage and efflorescence. Increased bond strength aids in the prevention of cracking water leakage and efflorescence.
This product is used as a chair to suspend rebar or welded wire in a freshly poured concrete slab.The Dobie maintains the reinforcement at the desired heighth as the concrete hardens around it. Provide rebar support. Ready to use.
Sakrete White Line Marker is a formulated blend of crushed white high-calcium limestone. It is ideal for use as a line marker for any outside sports activities where boundary lines must be made visible for players and spectators. It is non-irritating to the eyes and skin, and it will not harm soil or vegetation. No mixing required. If clumping occurs due to extreme moisture, simply tap lightly with a small shovel or other tool. One 50 Lb. bag will do approximately 300 Ft. of boundary line at 3 inches wide by 1/6 in. thick. Yield will vary with the amount of moisture present and type of spreader used. Boundary lines should be applied to dry ground
Sakrete Form Tubes offer an easier way to pour concrete footings, round columns, or piers for above or below grade applications. These one-time use cardboard forms ensure a beautifully finished end result. Available in 6″, 8″, 10″, 12″, 14″, 16″, 18″ and 24″ sizes
Designed for use with Rapid Set® cement products and most other packaged hydraulic cements, FLOW Control® performs two functions. First, adding FLOW to your mix will significantly increase the fluidity of the mixture. A stiff mix becomes soupier when using FLOW. Second, FLOW increases the strength and reduces the shrinkage of your mixture when you use the FLOW as a replacement for mixing water. When using FLOW, the same working consistency (or slump) may be produced with approximately 20% to 40% less mixing water.
The HC MUDDOX 50 lb. Fire Clay is used to make mortar to set block, brick and stone. The clay can be mixed with sand (not included) and cement (not included) to produce mortar and stucco.
This product is used as a chair to suspend rebar or welded wire in a freshly poured concrete slab.The Dobie maintains the reinforcement at the desired heighth as the concrete hardens around it. Provide rebar support. Ready to use.
Designed for use with Rapid Set® cement products and most other packaged hydraulic cements, SET Control® slows down the setting time of cement allowing you more time to place and finish your concrete, mortar, and grout materials. This extra time is often needed when making large or intricate placements (more than one cubic foot) of grout, mortar, or concrete. In warm weather when cement naturally sets faster, SET Control® works to slow down the hardening of the cement.